2 Roll 110
Compact wheel washer that fit in small & medium sized job sites
2 Roll 110
An efficient washing is possible because it forces the wheel to roll 360 degrees while the three dimensional nozzles are spraying water. This model is suitable for those sites situated in the down town or in the residential areas where public grievance are most likely to happen. While the existing S01EX model uses 8 rollers, this employs 4 long-axis rollers and strengthened roller bearings, thus improving durability and convenience of maintenance. CE certificate proves its safety.
- Automatic sludge discharge by conveyor system
- Automatic pump screen self-cleaning system
- Forced motor drive with a 3.7 kw roller motor
- Emergency stop button
- Maximizes user’s safety with a sensor
- Checks washing times with a counter
- Prevents reverse rotation when a car exits
- Chain tension control
- No need to install a separate water tank due to monolithic type
- Easy installation and withdrawal
- Easy to move with its 4 lifting lugs
| Dimension | W1,100 x L5,748 x H2,076 (mm) | |
| Applicable vehicle | Width of truck Max. 2,800mm | |
| Power consumption | 11.5Kw/h | |
| Gross weight | 3,200Kg | |
| Sensing | Limit Switch | |
| Submersible pump | 5.5Km x 380/460V x 3ø x 50/60Hz (Vertical) | |
| Roller drive motor | 3.7Kw x 380/460V x 3ø x 50/60Hz (Ratio: 1/50) | |
| Air compressor | 1.5Kw x 380/460V x 3ø x 50/60Hz | |
| Scraper drive motor | 0.75Kw x 380/460V x 3ø x 50/60Hz (Ratio: 1/173) | |
| Water jet pressure | 1.5~2.0kg/cm2 | |
| Main power | 380/460V x 3ø x 50/60Hz (Option) | |
| Water tank volume | 3,000 Liters | |
| Washing capacity | About 200 Vehicles/Day | |
| Nozzle | Side pipe – 10pcs, Main fram – 20pcs | |
| Side screen | 1 layer {Total 1m(H)} | |
| Side pipe | 2 inches x 700m(H) | |
| Pipe linking | 2 inches – Union type | |
| Control panel | Stainless Steel(SUS 304) /Dual door | |
| Heater (option) | 3Kw x 380/460V x 3ø x 50/60Hz |
Step 1: Entry
A car enters slowly into the wheel washer with a speed of 5 km/h.
Step 2: Washing front wheels
After entering, locate the front wheels (the 1st and 2nd axles) between the rollers of the washer and change the gear to neutral position. It will then automatically start to wash.
Step 3: Washing rear wheels
In the same way as the front wheels, wash them in the sequence of the 3rd and 4th axles.
Step 4: Exit
After washing, slowly exit from the washer and advance to the road.2 Roll 110
